Enclosure frame: Dipcoat-primed
Interior installation: Spray-finished
Rear door and roof: Dipcoat-primed, powder-coated
Front door: Aluminium, anodised/spray-finished
Enclosure frame with doors and roof plate
Glazed aluminium door at the front (180°), with comfort handle for semi-cylinder and security lock 3524 E
Rear panel
Roof plate, multi-piece, removable, with side cable entry in the depth and covered cut-out for fan mounting plate
Base module mounted at front as infill panel
Swing frame, large, with side trim panel for the installation of 482.6 mm (19") mounting components whilst utilising the full rack height, 130°
Side panels, one-piece, for screw fastening
Base/plinth system VX, 100 mm, vented
Base/plinth corner pieces and trim panels, sides, screw-fastened
Base/plinth trim panels, front and rear plus corner and baying covers supplied loose
4 levelling feet, M12, including base/plinth adaptor (supplied loose)
Spacers, height 50 mm, to raise a cover plate above the fan cut-out in the roof plate,for passive cooling (supplied loose).Not required for variants without a cut-out.
12x482.6 mm (19") fastener,1U, conductive (supplied loose)
25 multi-tooth screws,conductive (supplied loose)
4 combination rails for inner and outer mounting level,to fit rack depth (supplied loose)
10 cable shunting rings, metal,125 x 65 mm (supplied loose)
IPPC pallet
Base module mounted at front as infill panel,depth 175mm