VX enclosure frame with doors and roof plate
Aluminium/sheet steel door at the front,vented (vented surface area approx.85% perforated),180°hinges
Sheet steel rear door,vented (vented surface area approx.85% perforated),vertically divided,180°hinges
Lock front and rear:Comfort handle for profile half-cylinders and security lock 3524 E
482.6 mm (19") mounting angle,standard,variably screw-fastened to depth stays at the top and bottom
Side panels, one-piece,for screw fastening
Roof plate, multi-piece,with side cable entry in the depth,double-sided,prepared for fan mounting plate
Base module mounted at front as infill panel
Base/plinth system VX,100mm,vented
Base/plinth corner pieces and trim panels,sides,screw-fastened
Base/plinth trim panels,front and rear plus corner and baying covers supplied loose
4 levelling feet,M12,including base/plinth adaptor (supplied loose)
Spacers,height 50 mm,to raise a cover plate above the fan cut-out in the roof plate,for passive cooling (supplied loose).Not required for variants without a cut-out.
12x482.6 mm (19") fastener,1U,conductive(supplied loose)
25 multi-tooth screws, conductive (supplied loose)
4 combination rails for inner and outer mounting level,to fit rack depth (supplied loose)
10 cable shunting rings,metal,125x65mm(supplied loose)
IPPC pallet
Base module mounted at front as infill panel,depth 75mm.