Rittal cabinet power control unit module (PCU) active PSM,8 outputs,can be switched individually
This module has 8 current outputs with IEC320C13 slots. Each of the 8 slots can be switched individually (via the CMC-TC system). Also integrated into the module are a current display, a current loop and an overheating protection device. This socket strip can be mounted on the Rittal enclosures frame or on a 19”profile in a rack (1U). This module has double the length of a PSM standard module, so that on a 1200mm long PSM busbar Up to 2 Rittal cabinet modules can be plugged in, and up to 3 modules can be plugged in a 2000mm long PSM bus. The socket board has no CMC-Tc driver:
The driver of this type of socket strip requires power supply DK7201210 and a connecting cable. One power supply can drive up to 4 power outlet strips. It can drive up to 2/3 of the modules with one power supply on one PSM bus (1200/2000mm).
Useful functions: current display, current loop display, automatic selection on switch.
Socket board with CMC-TC driver:
No additional Rittal enclosures power supply is required, the modules are powered via the CMC-TC system. Up to 4×4 modules can be connected to one processing unit II (DK7320.100).
Useful functions: current display, current loop display and automatic selection on switch, 8 current outputs can be switched individually through the CMC-TC access network, current limit value monitoring, delay switching of a single current output, module status display.
7320.100CMC-TC processing unit Ⅱ7320.425CMC-TC power supply 24V input 100-230v AC
DK7320440CMC-TC1U mounting unit
DK7320472CMC-TC connecting cable sensor unit 2mDK7200210CMC-TC connecting cable D
230V AC (depending on the regulations of each country) 7200.221CMC-TC programming cable
Function Description:
2-digit local LED light-emitting diode 7-segment current display on the Rittal electric cabinet module. Readability is affected by installation site
Current sensing and monitoring of each module. Adjustable minimum/maximum limits.
Detection rangeO-16A
The Rittal Air Conditioner alarm signal is displayed via a flashing 7-segment display. The monitoring module of the thermal fuse can be combined via a bus system, which allows selective switching on. The 8 individual current outputs of the switching module can be combined with the CMC-TC via HTTP and SNMP independent switching power supply remote management, remote limit value change and monitoring, SNMP capture signal output when alarming
Aluminum component rack with plastic cover Scope of supply:
1 socket board module 1U (max. 10A per socket). 1 bus cable,
1 input cable, 24V DC,
Also required:
Standalone operation without CMC-TC requires a separate power supply (100-240V AC/24V DC) (DK7201210) and corresponding connecting cables.